*********************
                     MicroTerminal Program
                     *********************

This freeware terminal program can be used to configure 
or switch over a serial connection following devices:

- ePowerSwitch-4 Power Strip
- ePowerSwitch-4R2 Power Strip
- ePowerSwitch-1 Guard
- ePowerSwitch-1 GuardR2
- epowerSwitch-4 Guard
- ePowerSwitch 4M+
- ePowerSwitch-8 Guard 
- ePowerSwitch 8M+
- ePowerSwitch 8M+/32
- ePowerSwitch 8M+R2
- ePowerSwitch-M8
- ePowerSwitch-S8
- ePowerSwitch-8XM
- ePowerSwitch-8XMR2
- ePowerSwitch-8XS

 
Operating mode:
--------------

1/ connect the supplied configuration cable to an available 
   serial port on your computer and to the serial port of
   the ePowerSwitch

2/ start the MicroTerminal program

3/ choose the serial COM port you are using for the connection

4/ press <ENTER> until the prompt «>» appears on your screen.
   You are now in the command mode of the ePowerSwitch.

5/ press <TAB> to display the Configuration menu on your screen.
   You are now in the configuration mode.


Remark:
------

This program is FREEWARE and is distributed "as is". 
The author of this software does not guarantee that 
this software is free from bugs and takes 
no responsibility for program operating.

August 2011