Manual mode

In this section we will review the basic commands necessary to:

• Start a Run
• Control the Run Statistic
• Stop a Run
• Zero a Run
• kill_run
• Selecting and Modifying Devices
  • Experiment Magnets (GPS, DOLLY, GPD)
  • Superconducting Magnet (LTF)
  • Temp. Controller LTC20/LTC21
  • Temp. Controller LS340
  • Temp. Controller AVS46 (LTF)
  • TC44
  • Variox/Heliox Cryostats
  • Modifying other Devices
• Modify the DAQ Electronics Settings
  • Modify TDC Settings
• Getting a Warning
• Resetting the Run State
• Modifying the Midas Setup